Yard-Man 24A-061I401 Manual do Operador

Yard VacuumChipper/Shredder/Vacuum/HoseModel Number24A-061I401 IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLYMTD LLC P.O. BOX 361131 CLEVELAN

10Nozzle Height AdjustmentThe nozzle can be adjusted to any six positions, ranging from 5/8” to 4 1/8” ground clearance. The nozzle height has to be a

11MaintenanceEngineRefer to the separate engine manual for all engine maintenance instructions.• Check engine oil level before each use as instructed

12Figure 14• Remove lock nut that secures flail screen to the lower housing. The flail screen does not have to be removed. Refer to Figure 11.• Remove

13SECTION 6: TROUBLESHOOTINGNOTE: For repairs beyond the minor adjustments listed above, contact your nearest authorized service dealer. Problem Caus

14SECTION 7: PARTS LIST FOR MODEL 24A-061I401 2345678974111213141516171819202111232425262227282924303132333435583738394114041424344445464748505150525

15Model 24A-061I401Ref. No.Part No. Part Description1. 7510042823 Shoulder Screw #10 x.4572. 749-0438D Upper Handle3. 720-0279 Knob4. 712-3004A Flange

16Model 24A-061I4011234567891011121314151617181920211722232425262728293031323334353615373856404142434458*555960474849505152425354444645565761621515555

17Model 24A-061I401Ref. No.Part No. Part Description1. 664-0095 Bag Assembly2. 681-0154 Screen Assembly3. 710-1054 Hex Screw 5/16-24 x 1.0 4. 781-0490

18NOTES

19NOTES

2TABLE OF CONTENTSContent PageImportant Safe Operation Practices...3Assembling Your Ya

MANUFACTURER’S LIMITED WARRANTY FOR:The limited warranty set forth below is given by MTD LLC with respect to new merchandise purchased and used in the

3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESWARNING: This symbol points out important safety instructions which, if not followed, could endanger th

4i. Never store the machine or fuel container inside where there is an open flame, spark, or pilot light (e.g. furnace, water heater, space heater, cl

5WARNING - YOUR RESPONSIBILITY: Restrict the use of this power machine to persons who read, understand and follow the warnings and instructions in thi

6Attaching The Handle• Unfold the upper handle until it aligns with the lower handle.• Secure the two handles by tightening the wing nuts (carriage bo

7Attaching The Blower Chute (If Equipped) • Grasp blower chute with one hand and slide locking rod on mounting bracket with other hand toward engine.

8Chipper ChuteAllow twigs and small branches up to 1 1/2” in diameter to be fed into the impeller for chipping. Blower Chute (If Equipped) When attach

9• Twist the two buttons on the back of the bag to unlock and empty contents. See Figure 7.• Hold bag handle and bag clip while emptying the contents.